Quote from: Rob Blessin Black Hole on May 16, 2019, 08:18:38 pmHello: How are you doing the installation of NeXTSTEP 3.3 to the scsi2sd? Is it from using a saved Drive or ISO image using the DD (disk duplicate command) using terminal.app utility on MACOS X then copying the saved image to your sd. Then booting that newly created sd on your NeXT ? Or is the image on the SD from an original NeXTSTEP3.3 CD install or using buildisk from your original hard drive?I created a CD and floppy drive partition on the SCSI2SD, DD'd the installation disk images to those and installed onto SCSI ID0 HD partition.
Quote from: undefinedWhat happens if you choose to logout first then power off from the login screen?It hangs at the grey screen indefinitely just like a shut down.
Quote from: undefinedDo you have the password set for the me account so when you logout you have a login screen appear and can login as root or me ?I've only been using root. I don't think I have another user account set up but will check.
Quote from: undefinedIf when you boot up it goes directly into the operating system , you need to set up a password for me , using the calendar icon , click to open preferences , click the padlock in the preferences panel , set the password.It boots to a login screen. I log in as root.
Quote from: undefinedSo it lloks like error is referring d0 (0,0) sense key:0x2 additional sense code: 0x4It's a fresh install.
SCSI Block in error = 2285632; Partition a F.S. sector 1142656 to a bad sector on your sd card, this may be an artifact from a previous install say on older hard drive then moving data to your new sd drive.
Quote from: undefinedWhen you format the sd card does it give any errors for example using MACOSX utilities Master Boot Record Fat32?It didn't when it was new, but I haven't formatted it since installing NeXTStep
Quote from: undefinedWhat is your current set up .... as it gives us a starting point.....The optical drive is plugged into power, but disconnected from SCSI. If it's not plugged into power, the machine won't turn on.
What drive do you have jumper to be SCSI ID 0 ?
Do you currently have a hard drive ?,+ SD drive ? CDrom Drive? Floppy Drive? on your Cube?
Quote from: evolver56k on May 16, 2019, 05:30:05 pmCan you post your scsi2sd config file? you might have an issue with the drive definition
Quote from: barcher174 on May 15, 2019, 02:12:55 amI would suggest checking your SCSI cable. Which SCSI2SD version? Have you updated to the latest firmware?The SCSI2SD is 5.0b. I updated the firmware when I installed the card a couple months ago. It looks like the latest firmware available is from 2018 so I should be up to date.