Started by Rob Blessin Black Hole, July 01, 2019, 03:55:28 am
Quote from: krazycat on July 04, 2019, 08:04:39 amWhen a slab does not start, my diagnostic scheme is usually this: check battery> check power cord> unplug SCSI disk> unplug RAM > check power supply.
Quote from: barcher174 on July 04, 2019, 10:13:21 amWhat you're likely seeing is a board failure causing a short to ground on the logic board of the drive.
Quote from: barcher174 on July 04, 2019, 12:15:21 pmSorry Andreas that answer was for Rob. You are talking about an original color and not the turbo right? For the original I think it is 4 simms per bank. Can you hold them in place while powering up? You should at least see the machine power up and the diagnostic LED blink when the banks are not fully populated. It sounds like you may have more issues.