 |
NeXT Computers www.NeXTComputers.org
|
|


|
View previous topic :: View next topic |
Author |
Message |
pan1k
Joined: 17 May 2007 Posts: 91 Location: Los Angeles, CA
|
Posted: Fri Mar 02, 2012 1:51 pm Post subject: Anyone Familiar With HP 9000 735? |
|
|
I have an HP 735, it has the Fast and Wide SCSI option, which isn't recognized by NS 3.3. It has the module tho that houses the SCSI drives, and the connector on the module is SCSI 3. Will it work if I get a SCSI 3 -> SCSI 2 cable and patch it into the SCSI 2 Single Ended port on the main logic board? I have the internal drive pinned as ID6 and the CDROM as ID2. I bent a pin on the cable so I will have to wait a bit to see if it will work.. |
|
Back to top |
|
 |
Noth

Joined: 04 Apr 2008 Posts: 146 Location: Lausanne, Switzerland
|
Posted: Sat Mar 03, 2012 1:28 pm Post subject: |
|
|
I'd try the nekochan forum, they're much more versed in HP gear and scsi. HP 9000 hw was hardly the typical NeXT OS setup and us hobbyists usually do x86 or sparc. _________________ NeXT Cube 040 (NeXTSTEP 3.3), SUN SparcStation5 (NeXTSTEP 3.3), SGI Indigo2 R10000 (IRIX 6.5.22), SGI VSW320 (Windows 2000/Slakware 9.1) |
|
Back to top |
|
 |
pan1k
Joined: 17 May 2007 Posts: 91 Location: Los Angeles, CA
|
Posted: Wed Mar 07, 2012 9:35 am Post subject: |
|
|
Well, No luck. I had the drive pinned as ID6, I dried SE mode, no dice. I purchased an external 9gb SCSI drive from eBay, will try that next week. Getting closer though!!! |
|
Back to top |
|
 |
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Powered by phpBB © 2017 phpBB Group
|