NeXT Computers Forum Index NeXT Computers
www.NeXTComputers.org
 
Log in to check your private messagesLog in to check your private messages

Log inLog in  RegisterRegister


Profile  Search  Memberlist  FAQ  Usergroups
SCSI2SD v5.0b (4.8.1) config for NexTcube Turbo, 2GB card?

 
Post new topic   Reply to topic    NeXT Computers Forum Index -> New Technology
View previous topic :: View next topic  
Author Message
tiritea



Joined: 14 Sep 2017
Posts: 7
Location: Pahiatua, New Zealand

PostPosted: Sat Jan 19, 2019 8:15 pm    Post subject: SCSI2SD v5.0b (4.8.1) config for NexTcube Turbo, 2GB card? Reply with quote

I recently purchased SCSI2SD v5.0b (4.8.1 firmware) to replace the drive on my NeXTcube Turbo. I set it up with a config from here : https://ctrl-alt-rees.com/2018-09-19-nextstation-easy-scsi2sd-setup.html, and was able to install a clean OpenStep 4.2 onto it from my OpenStep 4.2 CD-ROM. The install went fine, no errors, etc, but now the cube simplt refuses to boot off it; I get a "sc: scintr program error" every time it tries to boot off the drive, and get throw into the monitor. Will boot fine off my actual hard drive, so it must be something with the SCSI2SD card and/or config.

So asking if anyone has a working SCSI2SD config xml file that is known to work for a v5.0b card with the latest 4.8.1 firmware, running under a turbo (040) system, that they can share. It'll be the only internal drive in the SCSI chain, so terminating resistor packs are left installed.

Thanks in advance.

- Gareth
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    NeXT Computers Forum Index -> New Technology All times are GMT - 7 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Powered by phpBB © 2017 phpBB Group